I decided to change it up one more time. I’m very content with this version. I redesigned it completely in fusion 360 and went through about 4 test prints before being satisfied with the end result.
…
This renovation happened in our previous home. It started with wanting to replace the sink faucet and we ended up gutting the entire bathroom. My wife and I were venturous enough to attempt to do all of the work ourselves. …
My wife and I purchased our home last year and as part of the inspection, I was told the hot water heater would have to be replaced soon. In Novemeber of 2012 we came across an after thanksgiving special. Jacuzzi …
This past weekends weather was amazing. The wife and I decided to take advantage and door some outdoor work. There is a shrub right outside our living room window which spans almost 4 ft in width. From the outside there …
This project is currently in progress!
I needed a place to store my tools and a small workshop to work out of. I started off by drawing s cheesy plan. Then went on to do something a tad bit formal …
This project was relatively simple and pretty affordable. We needed to update the kitchen as much as possible from what it looked like before. We decided to keep it simple and do a few things. Strip the cabinet doors and …
UPDATE:
I am working on a new prototype for the Ray gun. For addtional information, please go here
to read up on the 3d printed version of this Ray Gun.
How to build a Killer Klown ray gun
I …
